Kenwood DNX 9210 BT Rychlý návod stáhnout pdf (Strana 24)

EN 24

Quick Start Guide

Microphone unit

1) Check the installation position of

the microphone (accessory 8).

2) Remove oil and other dirt from

the installation surface.

3) Install the microphone.

4) Wire the microphone cable up to

the unit with it secured at several

positions using tape or other

desired method.

'JYBDBCMFXJUIBDPNNFSDJBMJUFNPGUBQF

Peel the release coated paper of

double-face adhesive tape to fix on

the place shown above.

Adjust the direction of the

microphone to the driver.

NOTE

t*OTUBMMUIFNJDSPQIPOFBTGBSBTQPTTJCMF

GSPNUIFDFMMQIPOF

Removing Procedure

Removing the hard rubber

frame (escutcheon)

1) Engage the catch pins on the

removal tool (accessory3) and

remove the two locks on the

lower level.

Lower the frame and pull it

forward as shown in the figure.

-PDL

$BUDI

NOTE

t5IFGSBNFDBOCFSFNPWFEGSPNUIFUPQ

TJEFJOUIFTBNFNBOOFS

2) When the lower level is removed,

remove the upper two locations.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

Žádné komentáře

Kenwood DNX 9210 BT Rychlý návod Strana 24