
Ipml70ll5
The remote control supplied with this receiver is also capable of controlling components from a variety of manufacturers once
0 you register the appropriate setup codes into the remote control unit.
Refer to "Remote operation of other components" for details about the operations available for each component. - 24
Wnen registering setup codes for KENWOOD audio components which are connected to this unit by system control cords, use the
following codes to insure proper system control operation: Cassette; 7000, CD; 8099, MD; 9000,
To control other KENWOOD components (VCRs, LD players, audio components not connected with system control coras, etc.) fo'low
the procedure described below.
Low battery warning
Replace all four paueries with new ones vv'hen yo.j notice a sr-iortening of the distance from wmch the '"er^mte connoi wih ooeraie or c me re-'-'Ote co”tro:
blinks 5 times vvhef' vou Dush a key The remote conrcl iS designed to retain set up codes m memory while 'vO'.j change catteries
Registering setup codes for other components
Find the setup code of the component to be
registered.
Refer to the setup code lists to find the setup code for the
component to be registered. - 17
Example: To register a CD made by KENWOOD, you would
enter"8037"
If you own a new component that is not covered by the
setup code list, you can use the FutureSet upgrade feature.
Hold down the ENT key until the backlight
flashes twice and remains lit.
ROOM B
input Component
Maker
Code
Key
(CD: CD piaver
KEN'WOOD
6626, 8037 ,AUDIO
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
TAPE1/MD
CD
PHONO
-
TV 1
-
TV 2
-
CABLE
•.At tr"s time all inputs oecorne ava'iable regardless of any earlier
reo'stratio".
Select the component to be registered.
Perform each of the following steps within
5 seconds.
Press the VIDEO, AUDIO, or TV
key repeatedly to select the de
sired component
AUDIO
VIDEO /'~N TV
o Q o
VIDEO key
1
VIDEOI (SAT)
2 VIDE02 (LD)
3 VIDE03 (VCR)
^ VIDE04(DSS)
r
AUDIO key
1
CD (CD)
2
TAPE1/MD
(TAPE)
_ 3 PHONO
TV key
1 TV1
I 2 TV2
L- 3
CABLE
Example : To register the component connected to the VIDEO 1 lacks.
select ''VIDEO 1 (SAT:i'.
FiOOM P
I I
r'i
r n T
.. I r"i I
Komentáře k této Příručce